Tuesday 15 June 2010

Make a velvet ribbon or braid belt



"Moneywise, fashionwise it's time to tighten our belts," says this early 1970s magazine article. As it was then, so it is now. If you have some odds and ends left over from another project, why not make a vintage-style belt?

Here's now to make the top Curved Braid Belt, made from two rows of braid machine-sewn to fabric. To fit a 61 - 71 cm waist, you will need 2m of 3cm-wide novelty open-weave braid, strips of toning fabric, lining and canvas each measuring 12cm by 91cm, a 6cm buckle, a press stud, matching thread.



Using squared pattern above, cut out a paper pattern in which each square = 5cm. 1.5 cm seams have been allowed throughout. Place pattern on fabric and cut out. Repeat with lining and canvas. Trim away seam allowance on canvas only. Cut braid into two equal lengths.

Leaving equal turnings along sides, place and pin the two lengths of braid centrally on to right side of fabric. Using matching thread, zig-zag or top-stich braid on to fabric. Tack canvas to wrong side of fabric. Wrap seam allowance of fabric over canvas along sides and ends. Tack and press in place. Oversew raw ends of thread before turning in to prevent fraying.

Pin wrong side of lining on to canvas and turn in all sides, covering raw edges of fabric to neaten. Press, hand stitch all round. At stright end of belt thread belt through bar of buckle and stitch end down on to back of belt. Sew press stud into position.

To make a Narrow Ring Belt:

By adding or substracting rings and adjusting ribbon length this belt can be made to fit any size waist. To make a 66 cm waist you will need: 1.5m of 1.5 cm wide black velvet ribbon, approx 48 brass curtain rings, fastening hook, matching thread.

To make: following above diagram, thread ribbon through rings to required length. Cut ribbon 2.5cm from the last ring at each end and turn back. Tuck in raw edge and stitch down. Sew hook on one end to fasten to ring at opposite end. With remaining ribbon make a small bow and stitch in place to cover hook.

Many thanks to Barbara for these brilliant belt patterns!

No comments:

Post a Comment